Milliput Standard

Milliput Putty - Standard (Yellow/Grey) - for repairing, modelling and sculpting.
 
The two sticks have a long shelf life but once mixed the resultant putty is at first soft and highly adhesive and then gradually hardens. Speed of hardening is dependant on temperature and at normal temperatures (20-25ºC) Milliput becomes rock hard in three to four hours. By the application of heat the setting time can be reduced to a few minutes.
 
 
After setting hard Milliput continues to cure and is fully cured after an elapse of time equal to the setting time at the same temperature. Once fully cured Milliput can be machined, drilled, tapped, turned, filed, sawn, sandpapered and painted. Milliput can be sandpapered and painted immediately after it has been set. (It is advisable to wear eye protection during this process).
 
 
Milliput is an excellent adhesive and will bond any of the following to itself or to any of the others - wood, brick, cement, metals, concrete, plastics and glass, but note that Milliput is not intended as a thin layer adhesive and should not be used where a paste, mucilage or thin glue is indicated. Milliput will set under water and is heat resistant up to 130°C.
 
 
Other uses of Milliput are as follows: mould making for casting can add on to build up wax model , ceramic porcelain repair, antique clock and watch dial restoration, marble, slate, cast iron, repair and restoration.